Canadian Solar Modules Pass PID Test for Third Consecutive Year
The PID test assesses how well modules can withstand the degradation phenomenon known as Potential Induced Degradation (PID). For a module to pass the PID test, its power degradation must be less than 5% following the PID test. Following test conditions are applied:
- Chamber air temperature: 60 degrees Celsius +/- 2 degrees Celsius
- Chamber relative humidity: 85% +/- 5% RH
- Test duration: 96 hours
- Voltage: -1000V
CS6P-P series polycrystalline modules have a power range from 235W to 255W. ELPS CS6P-MM series monocrystalline modules cover power output from 260W to 270W.
Dr.
How does PID happen? How to prevent PID from happening?
According to general consensus among solar system experts, the major root cause of PID is the combination of high level humidity and heat in an environment where a solar system is installed. Various studies have shown, and been confirmed by several PV solar systems in operation, that in a solar power system with P-type (C-Si) modules installed in a hot and humid area without negative grounding, a negative bias will build over time inside the module, between its internal circuit and the frame, thus giving rise to the PID phenomenon. PID high-risk areas include desert areas, tropical regions and locations close to water.
There are several ways to lessen PID effects:
- Special solar cell and module technology could enhance module level PID resistance
- Well-designed system configuration and proper installation according to installation manual
- Negative pole grounding
The most effective solution to PID problem suggested by PV system experts is to have negative pole grounding in the system installation. This way, the solar module array will have very high resistance to PID effect in a system.
About
Founded in 2001 in Canada,
Safe Harbor/Forward-Looking Statements
Certain statements in this press release are forward-looking statements that involve a number of risks and uncertainties that could cause actual results to differ materially. These statements are made under the "Safe Harbor" provisions of the U.S. Private Securities Litigation Reform Act of 1995. In some cases, you can identify forward-looking statements by such terms as "believes," "expects," "anticipates," "intends," "estimates," the negative of these terms, or other comparable terminology. Factors that could cause actual results to differ include the risks regarding general business and economic conditions and the state of the solar industry; governmental support for the deployment of solar power; future available supplies of high-purity silicon; demand for end-use products by consumers and inventory levels of such products in the supply chain; changes in demand from significant customers; changes in demand in our project markets, including
SOURCE
Ed Job, CFA, Director, Investor Relations, Canadian Solar Inc., ir@canadiansolar.com, or David Pasquale, Global IR Partners, +1-914-337-8801, csiq@globalirpartners.com
